Add Edges on the panel
Last updated
Last updated
After selecting the Add Edges command, a dialog is displayed that provides commands for automatic selection, or it is possible to select individual edges directly by moving the cursor to the desired edge and confirming the selection.
If a skeleton with previously selected and saved edges is selected (exit the dialog with the OK button), their number is displayed (2) and the edges are highlighted in the model.
Automatic edge selection, always works with only one selected skeleton. His selection is done by selecting from a list (1). Once selected, the selected skeleton is highlighted and the following commands are available:
(3) Selection of all meaningful edges on the panels that "wrap" the skeleton, if the assembly contains a back, which are located at the end of the skeleton, the edges from behind are omitted.
(4) Selection of leading edges on all inserted shelves.
(5) Select all edges on the inserted doors.
(6) Allows you to set the edge thickness. Applies to all selected edges.
(7) Allows you to add a layer thickness for the adhesive material.
(8) Delete saved edges that were in the selection (2).
It is possible to add or remove edges after the automatic selection has been made.
Using automatic selection will result in "unchecking" the command.
If you use its cancellation on any (3,4,5) order, the entire selection (2) will be canceled.